Extreme active break and wiring
The Mosfet unit is designed for electric
replicas. It cooperates with the NiMh type 8,4-12V voltage batteries and also
the LiPo type 7,4-11,1V battery packs. It is possible to use 1,5mm thick wiring
with it. The application of the Mosfet unit increases the rate of fire of the
replica, prevents the burn of the plug cube and secures the plugs.
This model is prepared to be used with the M170 main springs with the maximum rate of fire of 25 BB pellets/s. The set also includes 4 silicone wires that are 1,5mm thick and two classic signal wires which are 0,25mm thick. The length of the wiring on both sides is 50cm.
The active break causes the stop of the motor just after the trigger is released - this prevents the partial motion of the piston and the piston stops in the forwards position. In the case of the replicas with greater or increases rate of fire, the active break eliminates the possibility of shooting twice in the SEMI mode. The set includes a heat shrink guard.
The set includes the complete wiring.